Assembly
The cord is already installed on the rail saver. All you have to do is pass it through the plug, then pull and re-lock on the rail saver by the hook and loop strip. Thus the rail saver is automatically well positioned.
Hand protection
PLEASE NOTE : never hold your board with your hands or fingers wrapped in the cord. This can lead to serious finger injury.
Safety
Our leashes are tested under tensile strengths higher than the forces found during use on a surfboard. However, always check the condition of your leash before going into the water. Micro-cuts can affect its resistance. Regularly change your leash, especially if your board remains in the sun for long periods of time.
Double swivel
This prevents the leash from getting twisted up in the water.
Store rolled
To avoid deforming the cord, which can cause it to twist up in the water.
Rail saver
Protects the rail of your board from being cut by the leash rubbing against the edge.
Tips for storage and maintenance

Hand wash

Do not bleach

Do not tumble dry

Do not iron

Do not dry-clean
Storage tips
Do not store wrapped around the fins of the board to avoid kinks.
Restrictions on use
Not suitable for surfing large waves of more than 3 metres.