Waterproofing
- Membraned 2-layer fabric
- A strong rain corresponds to a flow of 100 l/m2/h - (= rainfall of 100 mm/h)
- The rainfall simulator reproduces these conditions for 3 hours.
- Component resistant to water pressure of 20,000 mm after ageing (= 20,000 Schmerber - average pressure of water during a storm)
- Water-repellent components (water runs off the fabric).
- 100% taped seams.
- Central opening features a flap with a drainage channel for optimal waterproofing
Breathability
RET <12: very breathable.
To find out whether a fabric is breathable, we measure its evaporative resistance, or RET, (test based on the ISO 11092 standard). It is its ability to allow the water vapour produced by the body during exercise to escape.
Comfort
3-way adjustable hood.
Adjustable jacket hem.
Reflective patches
2 shoulder patches
2 hood patches
to intensify light sources.
HOW TO REACTIVATE THE ANORAK'S WATER REPELLENCY
step 1: before washing
Close all zips and flaps and remove any parts of the clothing that cannot be washed. Also remember to loosen the straps and elastic parts and empty the pockets.
Then turn the clothing inside out to wash it.
HOW TO REACTIVATE THE ANORAK'S WATER REPELLENCY
step 2: washing
You can wash your jacket on a synthetic cycle at 30° or 40°C with your usual detergent. Do not use fabric conditioner, which could damage the existing performance of the garment, or bleach.
Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.
Very important: select a thorough rinse or double rinse to completely remove all detergent residue.
HOW TO REACTIVATE THE ANORAK'S WATER REPELLENCY
step 3: drying
Drying is a crucial phase in reactivating the water repellent treatment.
We recommend that you lay your anorak flat on a clothes rack and leave it out to dry in the open. Caution: never dry your anorak directly on a radiator.
Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round.
HOW TO REACTIVATE THE ANORAK'S WATER REPELLENCY
If, despite this procedure of washing and thorough rinsing followed by gentle drying in a tumble dryer, the drops of water no longer run off the surface of your jacket, we recommend that you "re-waterproof" it using a spray sold in our stores.
Tips for storage and maintenance
Machine wash - 30° max - normal
Do not bleach
Tumble dry - low heat
Do not iron
Do not dry-clean
Storage tips
The environmental impact of the product is calculated over its entire life cycle and with different indicators. An overall score (ABCDE) is attributed to help you easily identify the products